1 9

Amp Camp Amp Redux

Amp Camp Amp Redux

by Redux Kits

$280.00
$280.00
Sale Sold out

The original Amp Camp Amp circuit (V1.6) by Nelson Pass in a unique form factor optimized for easy assembly and reduced cost.

This kit contains all components, hardware, and power supplies needed to build two single ended class-A monoblock amplifiers.

  • 8 watts into 8 ohms
  • 10 dB gain
  • 10KΩ input impedance
  • Current stock uses JEFTs and MOSFETs sourced from Nelson Pass

6L6 at diyAudio has written detailed instructions to guide builders through the process.

Required tools:

  • Soldering iron and solder
  • Flush cutters
  • Voltmeter
  • 2.5mm hex key

To read about the history and development of this kit, jump into the discussion thread.

This extensive thread about the Amp Camp Amp is the best place to learn about the circuit itself.

If the Redux aesthetic isn’t your style, check out the version sold by the diyAudio Store.

 

In this kit:

Board Reference Part Quantity
- Circuit boards 2
- Heatsinks 2
Q1, Q2 MOSFET, IRFP048 4
Q3 BJT, ZTX450 2
Q4 JFET, 2SK370 2
J1 DC power jack 2
J2 RCA jack 2
SW1 Power switch 2
C1, C2 Capacitor, 1000µF 8
C3, C4 Capacitor, 10µF 4
P1 Trim potentiometer, 5k ohm 2
D1, D2 LED, 5mm, cyan 4
R1, R2 Resistor, 0.47 ohm, 3 watt 4
R3, R4 Resistor, 0.68 ohm, 3 watt 4
R5, R6 Resistor, 100 ohm 4
R8, R9, R14 Resistor, 1k ohm 6
R7, R11, R13, R16 Resistor, 10k ohm 8
R10 Resistor, 332k ohm 2
R12 Resistor, 39.2k ohm 2
R15 Resistor, 2.2k ohm 2
J3, J4 Screw terminal 4
- Binding post, red 2
- Binding post, black 2
- Standoff, M3 × 6mm, brass 8
- Standoff, M3 × 15mm, nylon 8
- M3 × 10mm screw 4
- M3 fender washer 4
- Belleville washer 4
- Thermal pad TO-247, alumina 4
- Thermal grease 1
- Power supply, 24VDC, 2.5A 2
- AC power cord 2

 

Note, the supplied power cord is a NEMA-15P to C13 (North America plug).

View full details